Scinor

in

Scinor® SMT600–S30
TIPS
S30 Datasheet
Datasheet: SMT600–S30
Submerged Ultrafiltration Module
Diagram Submerged Ultrafiltration Module

Scinor SMT600 series ultrafiltration modules utilizing our state-of- the-art Thermally Induced Phase Separation (TIPS) PVDF membranes provide the highest permeability, mechanical strength, and chemical tolerance in the industry. These modules are ideal for use in potable water, wastewater, desalination, and industrial applications. The SMT600-S30 retrofits major membrane vendor installations giving end-users a choice when replacing membranes.

Scinor SMT600-S series submerged ultrafiltration modules are applied in vacuum operation during filtration mode. Due to the membrane's hydrophilic nature and the unique module design, the SMT600-S series can accept a wide-range of even the dirtiest water. To maintain stable operation at the required capacity, backwash with aeration is employed at regular intervals and chemical cleanings are utilized on an infrequent basis.

Product Advantages

Excellent Filtered Water Quality
• Tight 0.1 μm pore size distribution
• Low fiber breakage rate
Long Operational Life
• High mechanical strength and durability
• >5000 mg/L Sodium Hypochlorite tolerance
Low Requirements for Pretreatment
• Open, immersed design

Low Operating and Maintenance
Requirements

• Low energy and chemical consumption due to higher permeability
• Automatic operation
Low Capital Cost
• High flux rates on all water sources
Small Footprint
• High hollow-fiber packing density
• Integrated air and hydraulic piping

Retrofit modules available for all major membrane suppliers
  ISO 9001 ISO 14001
SPECIFICATIONS
Scinor® Module Part Number SMT600-S30
Fiber Material Polyvinylidene Fluoride (PVDF)
Effective Area 323 ft2 (30 m2)
Nominal Pore Size 0.1 μm
Fiber ID/OD 0.7 mm/1.3 mm
Geometry Ф170 mm×1532 mm
Port Size DN50
Housing/Head Material ABS
Potting Material Epoxy Resin
Operating Parameters Temperature 33-104° F (1-40 C)
pH Range 1-11 Continuous
Max. NaClO 5000 mg/L
Backwash Flux 18-42 gfd (30-70 lmh)
Air Scour Flow 1.9-3.1 scfm (3-5 Nm3/hr/module)
CIP pH Range 1-13
Max. TMP 11 psi (0.075 MPa)
Operating TMP ≤6 psi (≤0.04 MPa)
Max. Backwash Feed Pressure 17.5 psi (0.12 MPa)
Filtered Water
Performance
Turbidity ≤ 0.1 ntu
Silt Density Index ≤3
E.Coli Removal non-detect
About Us Products Applications
Drinking Water
Wastewater
Desalination
Industrial
Direct Retrofit Service TIPS Fundamentals Contact Us

Scinor Water America, LLC
1440 Broadway, 23rd Floor
New York, NY 10018
800.774.1385
info@scinor.com | scinor.com

P23
P38
P40
P50
P51
P56
P72
P80
S26
S30
S50
Site Map | Privacy Policy © 2015 Scinor Water America, LLC | All Rights Reserved